Total Quick Strip M/L

PREPARATION:

Test an area to determine effects and dwell time before use. Always work in small, manageable areas. Pre-clean area and allow to dry prior to application. Protect all plants and vegetation. Mask off all surfaces that you do not want Total Quick Strip ML to come in contact
with. Do not dilute.

APPLICATION:

Shake well before use. Do not dilute. Apply Total Quick Strip ML liberally to a dry surface with a brush, roller or squeegee and allow to dwell a
minimum of 30 minutes. Depending on the temperature, type of coating, and number of coats, dwell time will vary from 30 minutes to 12 hours.
Do not allow product to dry before removing coating. Cover areas you do not want stripped cover with plastic or visqueen. Once Total Quick
Strip ML has started to lift coating from surface, scrape off residue and dispose of according to local, state, and federal regulations. Once coating
is removed be sure to clean the surface area of all remaining residues by scrubbing, rinsing, power washing, etc. Some coatings may require additional applications and dwell time.

COVERAGE:

Coverage will vary due to the type of coating/product being removed, temperature, and application methods, but is generally between 50-150 Sq Ft. per gallon.

CLEAN UP:

Clean up all equipment with warm soap and water or denatured alcohol. 

To treat contaminated soil, dilute 1 pound of baking soda in 5 gallons of water and apply to the ground at a rate of approx. 75 sq. ft. per gallon. After 1-2 hours, saturate the soil with water. Saturate with water 2-3 time per week for 1-2 weeks.