Ure-Seal H₂O – Clear Urethane Concrete Sealer

PREPARATION:

 1. Clean surface thoroughly with ICT Total Klean (700) all purpose degreaser and cleaner to remove dirt and oils. It is recommended that you also use a bleach/liquid chlorine solution to remove any visible or microscopic algae or mildew. Rinse thoroughly. 2. If you are applying Ure-Seal H2O over brick pavers it is recommended that you use ICT Total Prep (720) according to product directions. This will aid in the removal of efflorescence and condition / prep the pavers. 3. Pressure wash the entire area thoroughly to remove any residual chemicals.

APPLICATION:

 ICT Ure-Seal H2O is a two component product. Mix using a low speed drill or jiffy mixer for 1-2 minutes. If dilution is recommended, mix parts A & B before and after water is added. Do not whip air into the mixture. Apply with a sprayer or short nap roller. (rolling is only recommended for indoor applications) Do not apply too thick or a white haze or bubbling will form and stay. If a second coat is required, it must be applied after the initial coat is dry to touch and visually clear, usually within 3-6 hours, but before it cures completely, usually within 24-36, hours after the initial coat is applied. Brick Pavers or Hot Surfaces should be slightly dampened with a light mist of water prior to applying Ure-SealH2O. Do Not Over Hydrate. Hydrate surface only if conditions allow for adequate dry/curing time. Thin pavers with a sand bed should be thoroughly dry before applying Ure-Seal H2O. The use of a quality pump up sprayer/continuous sprayer is recommended. Always filter before filling. A moderate amount of material should be applied. Do not allow Ure-Seal H2O to puddle. If puddling occurs use a dry roller to “back roll” the material, a leaf blower, or a stiff push broom to maintain an even thickness. If you use a roller for the application of Ure-Seal H2O use a 1/4” nap or Micro Fiber roller cover. For dry rolling/ back rolling you will need a 3/4-1” roller cover. If you should see roller marks as you are applying, lightly mist those area with water immediately. This will allow Ure-Seal to settle and form a more even film. Rolling is never recommended on brick pavers. Travertine should be sealed with 1-2 coats of Ure-Seal H2O using the recommended mixing & dilution ratios. Broadcast ICT Non-Skid Broadcast Blend (495) or Diamond Dust (491) while Ure-Seal H2O is curing to reduce slipperiness.

COVERAGE:

Approx-200 –300 sq. ft. per gallon. Coverage rates will vary depending on substrate, textures, porosity, and application methods.

CLEAN UP:

Ure-Seal H2O cleans up easily with ICT Total Wash (760). Follow instructions on back label when using Total Wash (760). Sodium bicarbonate and water is also useful in removing Ure-Seal H2O residue from equipment immediately after application. Mix sodium bicarbonate and water at a ratio of 1 pound of sodium bicarbonate to 1 gallon of water and flush equipment thoroughly. Soap and water may also be used immediately after use.